 |
 |
 |
 |
|
Custom cushions (Art's Marine, Brockton, MA) - Sunbrella |
New Starting Battery (Rolls group 27) w/ West Marine battery tiedown |
Re-hung head door (outside swing) |
Re-hung head door (outside swing) |
 |
 |
 |
 |
|
Re-hung head door (outside swing) |
Head shelf removed. Head installed on floor |
Commercial Velcro applied to hatches |
FX-11 anchor, 200' 7/16 rode, 10' SS chain+shackles |
 |
 |
 |
 |
|
FX-11 anchor, 200' 7/16 rode, 10' SS chain+shackles |
Other side of head door |
12 gallon fuel tanks (2), SS brackets |
Blue Sea 8 breaker panel w/ backlight |
 |
 |
 |
 |
|
Numbers installed |
Bottom of mast shot (channel installed) |
Anchor light installed |
Anchor light, antenna mount +wire |
 |
 |
 |
 |
|
New Running light w/ foredeck light |
wires at bottom of mast |
Support for mast-less sunshade |
Support for mast-less sunshade |
 |
 |
 |
 |
|
mast-less sunshade using mast raiser |
mast-less sunshade using mast raiser |
mast-less sunshade using mast raiser |
mast-less sunshade using mast raiser |
 |
 |
 |
 |
|
Grab handle installed |
Grab handle installed |
House Battery, 1000w Inverter w/breaker, switch cluster (replaces 1-2 switch) |
Breaker and custom battery cables |
 |
 |
 |
 |
|
Inverter and custom battery cables |
BEP battery cluster - 2 on/off switches, parallel switch, and combiner - all in one |
Install roller while on board |
Tie a string/rope/sail tie in a loop around roller |
 |
 |
 |
 |
|
place foot in loop |
push down on loop |
while stepping, insert pin and secure |
|
 |
 |
 |
 |
|
New sail slugs installed - Harding Sails |
Transom Cover - Harding sails |
Transom Cover - Harding sails |
Custom Sail cover - Harding Sails |
 |
 |
 |
 |
|
Custom Sail cover - Harding Sails |
Stainless steel hatch holder installed |
Ready for the water |
Flag installed on mast carrier |
 |
 |
 |
 |
|
Cup holder installed |
prototype mast support - plywood and one mast raising cable. |
plywood laminated together. To be secured to boat with bolts at factory locations. Cable goes over the top secured on port and startboard |
loop in factory mast raising cable to reduce length of cable. Should be replaced with dedicated cable in the future |