Frequently Asked Questions

Processing cont’d

Do I always have to wash my biodiesel, and how much?

It depends.  Some biodiesel producers have been using unwashed biodiesel for years with out apparent problems.  Others believe the only ASTM quality biodiesel should be used in your applications.  It ahs recently been reported that highly-washed biodiesel can attract microbial growths (algae) which can foul fuel systems. A pH which is slightly higher (basic) than pure water will suppress most microbial growth.  Therefore, we recommend you wash your biodiesel until the wash water is no longer solid milk-white but only murky white.  The pH should be approximately 8:0 which is indicates quite clean biodiesel while remaining a poor medium for algae growth.

 

Can I make partial batches?

The FuelMeister™ is designed and set up to make either full or half-batches for your convenience.

 

Will I have to touch any chemicals or be exposed to nasty fumes?

The FuelMeister™ is a closed system, meaning that you do not have to touch or pour any liquid chemicals. Even the methoxide fumes are filtered out when pre-mixing your catalyst.  WE ALWAYS STRESS THE USE OF PROPER PROCEDURES AND SAFETY EQUIPMENT BY RESPONSIBLE OPERATORS WHENEVER MAKING BIODIESEL.  In fact, we provide the necessary safety equipment with your FuelMeister kit.

 

Equipment

What size processor do I need?

It’s based on supply and storage logistics. Our processor assumes you’re working with 1 barrel of oil and 1 barrel for biodiesel storage/delivery.

 

How much space will the whole setup take?

The processor size is 62” high x 25” diameter.  Then you’ll need a barrel each for oil, methanol and biodiesel, for a total of approximately 25 sq. ft.

 

Where should I place my processor?

Find a sheltered, secure and well-ventilated spot out of the flow of traffic.

 

C & E Biodiesel

"Factory Authorized FuelMeister Dealer"