The Rounders Table / rail_1

This picture shows more than just the rail but all of the cuts.

The 3/4" Plywood: This is the bottom of the table. The 1" outer piece will be screwed to the rail when it is completed and will then be placed just as it is shown here round the center piece from which is was cut. Use a jig saw and lightly sand when complete. The less messing you do with these two sections the tighter they will fit together when you are all done.

The 1/2" Plywood: This is the top of the table and for that reason only needs to be1/2" thick. After you cut the 60" round, measure in 4" and cut the rail. Then measure in another 4" and cut out the race track. You will left with a 44" diameter center piece which will become the table's padded "felt" center.