The Rounders Table / tabletop_1

This is a picture of the finished rail placed on the tabletop. The intent is to show how it will fit over the table top when complete. It is not screwed into the table because the 1" outer ring which is attached to the rail helps it stay in place. Shown in the center is the 58" piece from the 3/4" plywood. I admit that I have not given detailed instructions on attaching the tabletop to the base, but if you purchase a pedestal, I can almost guarantee that it will come with detailed instructions for attaching the table top and in most cases will even come with hardware. Some of the instructions will suggest using T-nuts. I did not use T-nuts because this is not a visible section of the table and I simply counter sank some screws and tightened it down.