Miscellaneous Mods
 

While replacing my clutch, I decided to do a few other
mods....

DynoTech, Aluminum one piece drive shaft
Steeda, adjustable Upper Control Arm
BMR, safety loop
Hurst, short throw shifter

DynoTech one piece aluminum driveshaft.

 

The transmission mounting end.

 

The pinion end has an aluminum adapter plate.

 

Initial setup.

I measured the transmission output flange at
2 degrees down.

Note: If I wanted to make the pinion parallel to the
transmission output flange, I would set the
pinion to 2 degrees up.
 

Since I wanted to add 2 degrees of negative angle
at the pinion, I set the pinion to 90.