HOME PAGE

*CLUSTER REMOVAL INSTRUCTIONS*

Pull the 2 knobs off the vertical heater controls (pull hard)
Remove screws holding the mirror switch & defog switch if your model is equiped.....Then
remove 4 screws hidden by them (2 each side). The left headlamp switch should
lift then pull out remove all the plugs. You may have to leave
the defoger and snake the harness through the dash cover.
Lift and pull out the heater control about 2 inches, untwist
the 2 light sockets on the right side and unplug the blower
speed control. there are (2) silver colored 1/4" screws on the left side that
screw from the front remove them, this will remove the cover
from the heater control. Be careful not to let the 2 little
rectangular plastic pieces fall off, they are slides for the
2 heating levers. Remove about 6 screws from the panel directly
below the column and drop that down. Now you should have easy
access to the nuts holding the dash cover in. Remove all 4 nut
using a 10mm socket with a piece of paper stuffed in the socket,
this will hold the nuts in the socket so you don't loose them.
Pull off the cover and remove the rest of the nuts holding the
display in. Last take a long screw driver and push off the clip
connected to the column, this is for the park indicator. It has
a string or wire that goes into the dispaly. Now just pull the
display toward you, there are no other wires attached.

When installing the only hard part is the heater cover. Be sure
of the following: The 2 rectangle slides for the heater controlls
are in place and slide into the cover correctly, there is a silver
metal arm on the right side that hookes into the cover before
installing the screws, this will take some time to get in place.
Also there is a small unseen plastic slide in the heater cover
that the right heater control arm has to slide into, this is to
change the color of the indicator at night when you move it up & down,
not all models have this. Feel free to ask me any questions.

Thank you, Carl
860-583-0629 Days only please. caferacer1@comcast.net

Installiation of the motherboard is simple:

Remove the 7 screws that hold the metal back cover on.
Next unplug the 2 ribbon flex cables at each end, they have a locking tab that must be carefully released.
The motherboard can now be unpluged from the cluster by pulling it straight out. There are no screws
that hold the motherboard to the cluster.