 |
Meadowdale Monza Wall Test
We used a ratchet strap to bend the 1/2 MDF board to the desired angle. We stopped at 25 degrees of banking for two reasons. First, I don't think the wood could handle bending any further without breaking and second, it was getting too tall, and since one of the driver's stations would have to look over the wall to the serpentine curves on the opposite side, I called it "good enough". Further modifications allowed cars to run a little lower in the bank, eliminating the need to chicane the lanes in the turn.
|
 |
Back to Father Bob's Home Page
|