This page is for a 10-inch span 2mm Depron sorta Monocoupe 110. Weight is 9.1g. It's profile to make construction simple and attaching equipment easy. It uses the Plantraco Micro-900 receiver and a 30mAh LiPoly cell. Actuators are the new BSDmicroRC MicroAct's, which weight about 0.41g each. Weels do not turn. The wheels and pants were laser cut from 1/64 light ply by Dave Wulff. They could have been done by hand, but this made the shapes easier to get right. Covering top and bottom is printed tissue drawn up in Corel Draw. Propulsion is a 4x11mm 10 ohm Didel pager, geared about 7:1 with watch gears in a gear drive made by Ralph Bradley. The spinner and prop holder was also made by Ralph. Prop is MCF carbon fiber 3.2x2.2 inch.