T
Shirts | Totes-Bags
|
Embroidered
Items | Decals | Blankets
& Afghans | Cool
Stuff |
Home
Vinyl
Graphic Information and
Instructions
®™
Disclaimer: The techniques described here are intended as an overview of the vinyl manufacturer's suggested installation and removal methods. GreythoundHut.com accepts NO responsibility for property damage, injury, or any other liability resulting from the use of these methods, or the installation of our decals on motor vehicles.
Definitions & General Info
Our vinyl graphics come ready to apply, and consist of three layers. The decal is sandwiched between a transfer/application tape (top layer) and a "wax" paper release liner (bottom layer). They are designed to be applied to just about any flat or gently curved, smooth, non-porous surface. By default, they are cut to be applied to the outside surface. If you need a decal cut in reverse, for installation inside a car window, you must specifically request this in the "leave a message" area of the shopping cart, and/or make the request via e-mail prior to placing the order.
We suggest these two application methods for our decals:
Center Hinge Method for Large decals
Side
Hinge Method for Small decals
Decal Removal: Decals may be gently heated with a blow dryer or other heat source to loosen the adhesive. Lift the edge of the graphic piece you want to remove, and peel it away. Any adhesive left behind can be removed with a cleaner that is safe for use on the application surface.
