OARS NT7H Repeaters

Olympia Eastside Water Tower:

• 147.360, + Offset, and a Tone of 103.5

Crawford Mtn. East of Tenino:

• 441.400, + Offset, and a Tone of 103.5
• 224.460, + Offset, and a Tone of 103.5 
  

Repeater Command Codes (updated May 2004)

Radio Test Functions:

Keypad Test with Voice Read Back
Hold Mike Key and enter: 047 +(DTMF digits)C - Release the Mike Key
The system responds by audibly giving the digits entered.

Audio Test
Hold Mike Key and enter: 163C (say something) - Release the Mike Key
This is an Audio test with the Audio played back immediately

AutoPatch Functions:

Basic AutoPatch
Hold Mike Key and enter: * +(Phone Number)C - Release the Mike Key
The system responds with the phone number to be dialed.

Stored Auto Dial Slot
Hold Mike Key and enter: * +(Memory Number)C - Release the Mike Key
The system responds with the Memory Slot to be dialed

Disconnect The AutoPatch
Hold Mike Key and enter: #C - Release the Mike Key
The system responds with: "AutoPatch Off at (time) Please Identify"

Quiet Mode Functions:

To Enable Normal Mode with Voice messages.
Hold Mike Key and enter: 600C - Release Mike Key
The system responds with: "CW IDs Off"

To Enable Quiet Mode with CW identification only.
Hold Mike Key and enter: 601C - Release Mike Key
The system responds with: "CW IDs On"

Linking Functions: (Work in progress may not be working)

To Separate the 3-way Repeater System
Hold Mike Key and enter: 610C - Release Mike Key
The system will respond with:

To Link the 3-way Repeater System
Hold Mike Key and enter: 611C - Release Mike Key
The system will respond with:

To Separate the 2M Repeater from the System
Hold Mike Key and enter: 620C - Release Mike Key
The system will respond with:

To Link the 2M Repeater to the System
Hold Mike Key and enter: 621C - Release Mike Key
The system will respond with:

To Separate the 220 Repeater from the System
Hold Mike Key and enter: 630C - Release Mike Key
The system will respond with:

To Link the 220 Repeater to the System
Hold Mike Key and enter: 631C - Release Mike Key
The system will respond with:

To Separate the 440 Repeater from the System
Hold Mike Key and enter: 640C - Release Mike Key
The system will respond with:

To Link the 440 Repeater to the System
Hold Mike Key and enter: 641C - Release Mike Key
The system will respond with:

Notes:

For most operations the "C" Execute Command code is optional and can be replaced by just releasing the mike key. It is required to combine two or more commands at one time.

When restoring the link to the 220 or 440 repeaters when they have been isolated from the system, and attempting to restore the link from the isolated repeater. It may be nessary to use "D" for the Execute Command code instead of "C".