The transmission inards all cleaned up
The transmission case ready to reassemble
Assembled, painted and installed, some assembly lube can be seen on the sliding splines
The shaft from the front of the transmission seen from inside the clutch housing
The throw-out bearing lubed and installed
There is a stud on the lower end of the transmission to hold this spring
The shifter rails seen with the detent balls, springs and interlock pin and plungers
Shift forks, lugs, reverse latch rod, spring, and washer, lever retainer and snap ring
The shift lever has a long slot for the reverse latch rod,
The shift lever pivot pin wears into the slot where the big bulb is,
this causes the shifter lever to swing loosely.
This slot has been repaired and a larger pivot pin machined and installed
From the bottom after assembly and stainless locking wire.