This was a rendering done in 3DS when I was trying to figure out how I wanted the layout of my shop to be.
This is the business end of my shop where all the fun stuff happens. As you can see it needs some finishing touches still. I have about 22 feet of bench top, which in planning looked good but it fills up fast. The bench also has a built in vacuum system with 4 ports. These are a few of the Machining tools I've bought over the last year. I had to part with a lot of stuff on ebay to afford it but they were worth it in the long run.
This is the Reloading side of my bench, I have a Dillon Square B, an XL 650, Lee Load All for shotgun, and a good ol Rock Chucker.
This is my MicroLux 7 x 14 Mini Lathe.
And you have to have a Mill to go with the Mini Lathe so is my Micro Lux Mini Mill. Then I had to have the computer so when I convert the Mill to CNC later on down the road.
And last but not least a Vertical / Horizontal Band saw with custom stand with built in reciprocating coolant system. (Click picture to see more) Someone asked how I fit the other presses on my bench. Here's how, I have a section that is removable and each press has its own slider.
Here is the Blank slider removed.
Here I have the Rock Chucker installed and ready to load some .44's
My Lee Load All. I love this thing, its so simple yet it works great.
 Sliders can be built for just about anything you need. I use to have the Square B on one too, but started using it so much it found a permanent place on the bench. I still would like to get a strong mount for it though.