CONNECTORS, SERVOS
&
ACESSORIES
|
PITLAB VARIOMETER NEW HOT ITEM ONLY 9 LEFT IN STOCK |
|
|
USES A STANDARD 2 WAY RADIO (FRS
BAND) FREQUENCY OF VARIO IS SET WITH DIP
SWICHES. SOLD AT MANY SPORTING GOODS STORE. SEE SAMPLE OF RADIOS BELOW.
|
THIS DEVICE BLOWS AWAY ALL OTHERS WHEN IT COMES TO REPORTING OF
THERMALS ALTITUDE AND RX IT IS ALSO CAPABLE OF GRAPHING OUT YOUR FLIGHT FOR EVALUATION
PURPOSE. VIEW YOUR ALTITUDE AT ANY GIVEN TIME, TEMPERATURES, PPM SIGNALS, AND
MANY MORE RECORDED DATA.
|
|
HOT NEW ITEM 2S, 3S, 4S, 6S LIPO
LOW VOLTAGE AUDIO ALARM |
|
ON 2S LIPO PACKS THE ALARM GOES OFF
IF BELOW 6.8V PERFECT FOR CAR PACKS. |
WORKS WITH ALL LIPO
BATTERIES. CHOOSE YOUR VOLTAGE NOT FOR LI-FE NOT FOR NIMH THE LOW VOLTAGE
ALARM WARNS YOU WHEN THE VERY EASY TO
INSTALL. MOUNTS ON THE BATTERYS BALANCE CONNECTOR OR CAN BE SOLDERED DIRECTLY
TO THE ESC. GREAT ALARM FOR RC
CARS OR PLANES WITH BRUSHED MOTORS AND ESC WITH NO LIPO CUT OFF. GREAT
SECONDARY WARNING SYSTEM EVEN FOR ESC WITH A PROPER CUT OFF. PERFECT FOR LIPO RX
PACKS LOW VOLTAGE WARNING. |
|
HOT NEW ITEM DELight STARTER KIT |
|
THIS SYSTEM COMES PRELOADED WITH A
LIGHT SCHEME IF THIS IS A LITTLE OVER YOUR COMPUTER
SKILLS, PLESASE GET THE LAZER LIGHTS AIRCRAFT POSITION SYSTEM, JUST DOWN
BELOW
|
Product Description:
The DELight Starter Kit
combines all the components of the DELight
programmable lighting system into one package. It consists of a programmable
lighting controller, software for creating customized lighting sequences, a
USB link cable to load the progra The DELink software is
easy to use and completely graphical. A simulator allows you to preview and
fine-tune your progra The DELight Ultra Bright
LED's are the brightest LED's ever used in an R/C lighting system. They are up
to 15 lumens each and can each draw up to 150mA. Not
to worry, the DELight controller can handle this
level of power, and if you're worried about blinding yourself, the controller
has programmable brightness! The DELight Controller
has eight output channels. It contains onboard non-volatile memory to store
your progra
|
|
HOT NEW ITEM DE-SW033 VOLTAGE
REGULATOR 3.3V |
|
|
HOW WOULD YOU LIKE
TO SKIP CHARGING A TX FOR A WEEK, HOW ABOUT 6 MONTHS WITHOUT CHARGE?? THIS MOD REQUIRES
LIGHT SOLDERING DX6 USERS PROBABLY
DONT HAVE TO WORRY ABOUT THE WARRANTY SINCE ITS
MOST LIKELY EXPIRED ANYWAY. |
|
HOT NEW ITEM 2S-6S VOLTAGE CHECKER MONITOR IN STOCK |
|
|
WORKS WITH MOST VERY ACCURATE
UP TO 0.01V UNLIKE THE
OTHER CHECKERS THIS ONE SHOWS VOLTAGE WITH LARGE CLEAR DIGITS. THIS IS NOT A
BALANCER |
|
HOT NEW ITEM 1S-4S CELL STATUS
CHECKER IN STOCK |
|
|
WORKS WITH MOST THIS ONE IS VERY
LIGHT AND CAN BE USED IN FLIGHT. VISIBLE BRIGHT LED
WILL ALERT YOU IF CELL DROPS BELOW 3.3V GREEN LED =
ABOVE3.3V RED LED = BELOW 3.3V
NOT REALLY
RECOMMENDED FOR LI-FE SINCE THE WORKING VOLTAGE CAN BE AS LOW AS 2.5V |
|
HOT NEW ITEM Model Aircraft Airspeed
Instrument |
|
|
A MUST FOR SPEED FREAKS WITH FAST STRYKERS AND PYLON SPEED DEAMONS
SO TINY, IT CAN BE MOUNTED IN SMALL SCALE AIRCRAFT |
NEW! How Fast
- 1 KM/H resolution for MERTIC |
|
HOT NEW ITEM Model Aircraft Altimeter |
|
|
|
NEW! How High? Model
Aircraft Altimeter flash-flash
flash = 421 feet |
|
HOT NEW ITEM Model
Aircraft Altimeter & Speed READER |
|
|
Included, installed battery (CR2032) lasts over a year
Download the instruction sheet for complete details. |
See How |
|
Aircraft Position Light System |
|
|
You may have seen other light syste
Works great on helicopters like the
Blade CX and CX2 Install in large or small helicopters
and planes Blinking red and green lights and
fast flashing LED strobe make this system superior over any other, the
ability to cycle through 5 light settings while still in the air is a cherry
on top of a cake ALSO AVAILABLE IN V3 with pre
programmed MODULE for Retracts (turns on Landing / Aproach
lights) Standard 5 lights 1 red 1 green 1 strobe 2 solid white
|
New LOW COST Lighting system Plug in the Lazertoyz RC LITE
Controller up to your receiver just like a servo and use your R/C radio
Transmitter to control the "RC LITE SYSTEM" YES ! Switch or Stick controllable while flying ! Turn on your lights while flying and you landing lights on final approach .. Now how cool is that ?! With 5 LED outputs - Control Up to 20 or more LED'S Completely pre-wired with 4 Ultra Bright LED's !
Pre-wired LED Lights. One each of Red & Green position lights ,
and 2 white LED's (1-landing and 1- strobe) ! Add more LED's for $2.00 each. Use up
to 20 LED's
|
|
HOT NEW ITEM 2S CAR LIPO DEEP DISCHARGE
PROTECTOR |
|
|
|
PROTECT YOUR 2S
CAR/TRUCK LIPO FROM DEEP OVER DICHARGE FOR TRUERC 2S LIPOS YOU WILL NED
THE TrueRC 2S to EQUINOX ADAPTER TO WORK WITH THE JST XH CONNECTOR THATS MOUNTED
ON THIS DEVICE. |
|
HOT NEW ITEM LIPO SHIELD |
|
|
|
LIPO SHIELD LipoShield is a low voltage cutoff device which enables
any ESC to be used with lithium battery packs. It installs
easily between your receiver and ESC and provides a reliable 3.0V per cell
soft cutoff to prevent over-discharge damage to your expensive lipo packs. LipoShield is a soft cutoff, so it is appropriate for any plane, even 3D
types. The soft cutoff gradually reduces power to the motor allowing you to
make a controlled landing. When you notice
the aircraft becoming sluggish, it is time to bring it in. The cutoff can be
reset by throttling down to zero, then throttling back up. This enables a go
around to prevent emergency landings and long walks to retrieve your plane. LipoShield automatically detects the number of lithium cells in your
battery pack at power-up and sets the appropriate cutoff voltage. It then
continuously displays the detected number of cells by blinking the Cells
LED. LipoShield works whether youre running a BEC
built into your ESC, a separate BEC such as Park BEC, UBEC or even a receiver
pack. LipoShield uses a microcontroller to modify the throttle signal sent from
the receiver to the speed control. As a result, it works equally well with
older ESCs that have no lithium cutoff settings,
and new ESCs that have unreliable cutoffs. It will
even work in conjunction with another soft cutoff built into your speed
control. LipoShield works equally well with brushed or brushless ESCs. |
|
HOT NEW ITEM CELL SHIELD |
|
|
|
CELL SHIELD CellShield is a low voltage cutoff device which provides
cell-by-cell protection for lithium battery packs. By monitoring each cell
individually, CellShield prevents individual cell overdischarge due to pack imbalance or cell variations. CellShield provides a soft cutoff when the lowest voltage
cell of the pack reaches the set minimum voltage. The minimum voltage is
adjustable from 2.5v/cell to 3.5v/cell. This lets you set the proper cutoff
voltage for your specific pack. For example, 8-10C cells typically use a
3.0v/cell cutoff, while 20C cells work better with a 3.2v/cell cutoff. CellShields cutoff voltage is set with an easy-to-use
potentiometer. There are no programmers to buy or complicated programming
procedures. With CellShield, you turn the arrow to
the cutoff voltage you want and go fly. CellShield also features optional thermal probes, which
prevent pack damage due to overheating. When using the thermal probe, if the
battery temperature rises above 150 degrees, CellShield
will reduce the throttle command sent to the ESC in an attempt to bring the
battery temperature back down. If the battery stays above 150 degrees, CellShield will enter soft cutoff mode. When using the
thermal probe, CellShield alerts the user to
temperature faults by flashing the red Temp light. The thermal probes are
extremely thin, and can often be inserted between the innermost cells of the
pack, where pack temperature is highest. CellShield installs easily between your receiver and ESC.
Simply plug the battery port on the CellShield into
the tap connection on your battery, and it will automatically detect the
number and cell order for any pack with .1 tap spacing. If you are running a
battery with 2mm tap spacing like Thunderpower, a
2mm to .1 adapter is all that is required to use CellShield.
Suitable Thunderpower adapters can be found here. CellShield will then light an LED corresponding to the
detected cell. You can even plug the
battery tap in backwards and in any position, and CellShield
will operate correctly. No soldering is required to install CellShield. CellShield works with any ESC and power system except some opto-isolated ESCs when used
with receiver batteries. For cell-shield to operate, the battery ground and
radio ground must be at the same level. This is the case for all ESCs with a built in BEC (whether or not the ESCs BEC is being used) and all ESCs
using external BECs. |
|
3 Pairs 2mm gold plated connectors IN STOCK |
|
|
|
PERFECT FOR
ALL OF OUR OUTRUNNERS 300 & 400 SIZE, AS WELL AS ALL OTHER MOTORS THAT DO
NOT EXEED 20A |
|
2 Pairs 2mm gold plated connectors IN STOCK |
|
|
|
PERFECT FOR ALL
SMALL BRUSHED MOTORS 180 UP TO 400 SIZE |
|
3 Pairs 3.5mm gold plated connectors IN STOCK |
|
|
|
PERFECT FOR
ALL OF OUR OUTRUNNERS 300 & 400 SIZE, AS WELL AS ALL OTHER MOTORS THAT DO
NOT EXEED 50A |
|
3 Pairs 4mm gold plated connectors IN STOCK |
|
|
|
PERFECT FOR
ALL OF OUR OUTRUNNERS 400 SIZE and UP, AS WELL AS ALL OTHER MOTORS THAT DO NOT
EXEED 130A |
|
1 Pair 6mm gold plated connectors IN STOCK |
|
|
|
PERFECT FOR
HIGH POWER SETUPS,RECOMMENDED TO BE USED ON 10S
& HIGHER |
|
|
|
|
|
Great for all
standard and custom packs HOW TO CHOOSE CORRECT SIZE? WE WILL USE
PURPLE AS OUR EXAMPLE Testing to see if Heat Shrink Large
enough Testing to see if Heat Shrink will
shrink enough. |
|
7.8g Hitec HS-55 micro servo |
|
|
|
Perfect
for all park flyers and 3D planes |
|
Hitec HS-65HB Mighty Feather Micro Servo |
|
|
|
Perfect
for all park flyers and 3D planes FEATURES: HS-65HB has long lasting and durable Karbonite gears. One of the slimmest micro servos
available Hitec's most powerful servo in the micro
class. The HS-65HB was created for higher performance micro helicopters,
electric Park Flyers, & 1/18 scale cars, and features a top ball-bearing
for long life and positive centering INCLUDES: (1) HS-65HB Micro Servo (4) M1.7x7 servo
mount screws (1) Two-sided
servo horn (1) One-sided
servo horn (1) M1.7x3 servo
horn screw (1) Four-sided
servo horn |
|
BA-TS-3.6
Blue Arrow Servo parts IN STOCK |
|
|
|
|
|
ADD ADDITIONAL HORN SET |
$2 |
|
PROP
SAVERS IN STOCK |
|
|
PROP SAVER for 3.17mm shaft Fits APC and GWS props |
$3 |
|
PROP SAVER for 3 mm shaft Fits APC and GWS props |
$3 |
|
SMALL ARMY SURPLUS AMMO CAN FOR LIPO CHARGING/STORAGE $15
|
IF YOU HAVE PROBLEMS LOCATING AN
ARMY SURPLUS STORE NEAR BY AND WOULD LIKE ONE OF THESE WITH YOU THEY ARE PRETTY CHEAP AND WHEN PREPARED PROPERLY, WILL LIMIT THE DESTRUCTIVE FORCE OF A LIPO FIRE IF ONE WAS TO HAPPEN. THEY ARE ALSO GREAT FOR STORAGE AND
GIVE YOU A BIT OF PEACE OF MIND, NOT MENTION THEY ARE CHEAPER THEN HOME
INSURANCE DEDUCTIBLE. |
