GS-35b HF Amplifiers
by
WB8WJU


Using the MLA-2500 as a basis for a GS-35B HF PA.


Building a GS-35B HF PA from scratch.


A power supply suitable for a GS-35B PA.


Dentron 160/10L Conversion


GS-35 Socket


AL-1200/Conversion to GS-35b Russian Triode


CONVERSION OF HENRY 2K-5


SINGLE GS-35B RUSSIAN TRIODE


PAIR OF GS-35B RUSSIAN TRIODES


TITAN 11 CONVERSION FROM 4CX1600 TO A PAIR OF 4CX800


MY PERSONAL AMPLIFIER

AL-1500 CONVERSION TO A PAIR OF 8877,S

HomeBrew 3CX3000A7 Amplifier

Home Brew 3CPX5000A7 Amplifier

Turning an MLA-2500B into a GS-35B HF RF Deck

The remote Power supply is 0-5000 VDC @ 2 AMP, CCS. Running at 3500VDC no load, it pulls down to 3300VDC under full load. Plate current is 600-700 mA and grid current runs about 200 mA with 100 watts drive. Idle grid current is 100 mA with a single 50 volt, 50 watt zener for bias. This PA is capable of between 1700-1900W output on most bands, using the stock MLA-2500B tank circuit. Input is untuned, as a properly tuned GS-35B presents an input impedance which "looks" enough like 50 ohms to please any transceiver/driver!

Click on picture for zoom .

MLA-2500 with original tubes removed, power supply removed, and GS-35 socket installed in former power supply compartment.

 

As above, side view, also with additional bracing for GS-35 socket installed.

 

As above, view from front.

 

Bottom view, showing blower and holes in former power supply chassis taped over with packing tape to insure all air will pass through the GS-35 cooling radiator.

 

Top view showing tape on TOP of power supply chassis floor as well. The GS-35 socket enclosure has been installed, and wiring of control interface has begun in rear left corner of tank circuit compartment.

 

As above, with additional cabling and T/R relay circuitry added.

 

As above, showing more cabling added in tube / metering compartment. The big black cables are actually split flexible cable sheathing.

 

MLA-2500 with meter switches removed and meter swapped out; 1.5A for plate current, 1.0A for grid current - probably could use 0.5A for the grid. Note nifty name plate to cover holes left when switches were removed.

 

MLA-2500 GS-35B RF deck in-line. The power supply is under the table. Belden 40 KV HV cable and millen HV conecters are used for HV connections.

 


go to the top